中空玻璃膠機除了丁涂層機、雙組分膠機,在很長一段時間的使用和選擇的一般配置情況下,會出現感覺手的壓力是不夠的,那么,是什么導致了它,我們應該如何解決這個問題?
　　In addition to the butyl coating machine and the two-component glue machine, the pressure of the hand is not enough under the long-term use and selection of the general configuration of the insulating glass glue machine. Then, what causes it and how should we solve this problem?
　　橡膠混合問題
　　Rubber mixing problem
　　當我們混合的時候，我們用手混合，直接暴露在空氣中。
　　When we mix, we mix by hand, and we're exposed directly to the air.
　　第二中空玻璃橡膠廠生產問題
　　Production problems of the second insulating glass rubber factory
　　雙組分上膠機自動混合后，上膠機自動混合后的這種情況，是廠家沒有按照嚴格的工藝流程將部件中的空氣去除造成的。
　　After the automatic mixing of the two-component gluing machine and the automatic mixing of the gluing machine, the manufacturer did not remove the air in the parts according to the strict process flow.
　　
　　那么如何解決這些問題呢?
　　So how to solve these problems?
　　1 .液壓站壓力不穩定，將混合芯軸清洗試試
　　1. The pressure of the hydraulic station is not stable. Clean the mixed mandrel
　　2. 攪拌不均勻主要是由于u型管內的粘接劑凝固，需要定期清洗。
　　2. The uneven mixing is mainly due to the solidification of the adhesive in the U-shaped pipe, which needs to be cleaned regularly.
　　以上就是對雙組份打膠機壓力不足的解決措施的詳細介紹，想要了解更多請點擊官網http://intelyalan.cn
　　The above is a detailed introduction of the solutions to the pressure shortage of the two-component dispenser. For more information, please click http://intelyalan.cn